#Motu 828 mk iii review full#
#Motu 828 mk iii review code#
#Motu 828 mk iii review Pc#

Output word clock that matches current rate, or corresponding 1x rate when operating at 2x or 4x.ДSP-driven phase lock engine and internal clock source produces imperceptibly low jitter characteristics (below the noise floor), even when the 828 mk3 is resolved to an external clock source via SMPTE time code.Дedicated Longitudinal TIme Code (LTC) input and output. Resolve to external word clock sources at sample rates up to 192 kHz. Independent 24-bit RCA S/PDIF in/out at sample rates up to 96 kHz. The 2nd phone jack always mirrors the main outs. One phone jack is assignable: operate as an independent output or mirror any other output pair. Control volume of all monitor pairs with the front panel MAIN VOL knob or your software. Add additional monitor pairs connected to balanced TRS outputs. Or map the pedal to any keystroke function in your host software.ДЄdd additional interfaces for more I/O as your needs grow.Д¬onnect your primary powered studio monitors to separate XLR main outs.

MIDI I/O is sample-accurate with supporting software.Д¬onnect a standard foot pedal switch (sold separately) for hands-free punch-in and punch-out while recording. Mix and match formats between the two banks.Д¬onnect a MIDI controller and/or sound module with no separate interface needed. Fine-tune the balance of your analog inputs and then save/recall trim configurations.ДЎ6 channels of ADAT lightpipe, 8 channels of SMUX (96 kHz) or two pairs of stereo TOSLink. Mic/guitar input limiter prevents digital clipping and distortion from overloaded signal levels up to +12 dB over zero.Д®ight 24-bit 192kHz analog inputs and outputs on balanced/unbalanced 1/4' TRS jacks.Дigitally controlled analog trim on all analog inputs (mic/guitar inputs + quarter-inch TRS inputs) provides accurate adjustments in 1 dB increments. Two front panel combo jacks provide hi-Z 1/4вЂќ guitar input or XLR mic input with phantom power, pad and plenty of gain.ДЄdd your favorite outboard EQ, preamp, reverb or other processor to the two mic/guitar inputs, before the signal goes digital. Or add send/return loops for outboard gear - with no latency. Need to tweak the mix? Do it on site using the back-lit LCD and front-panel controls.Д¬reate different monitor mixes for the main outs, headphones, or any other output pair.

Program your mixes at the studio and then bring the 828 mk3 to your gig - no computer needed. There's no channel sharing in the 828 mk3 the mic inputs, S/PDIF I/O, headphone out and main outs all operate as separate channels.ДЇlexible 28 input/16 bus mixer with on-board DSP effects, including reverb with sends/returns, plus EQ and compression on every input and output.ДЄccess any setting in your entire 828 mk3 mix directly from the front panel.

#Motu 828 mk iii review Pc#

Compatible with FireWire 1 and 2.Д¬onnect to any Mac or PC using High-speed USB 2.0 (compatible with USB 3.0).

#Motu 828 mk iii review full#

Take full advantage of all that Thunderbolt has to offer.